operation manual
Table Of Contents
- 1 Einleitung
- 2 Geräteregistrierung
- 3 Ausstattung und Bedienelemente
- 4 Technische Daten
- 5 Sicherheit
- 6 Inbetriebnahme
- 7 Betrieb
- 8 Demontage des Antriebs
- 9 Trailern/Slippen des Bootes
- 10 Fehlermeldungen
- 11 Pflege und Service
- 12 Allgemeine Garantiebedingungen
- 13 Zubehör
- 14 Entsorgung und Umwelt
- 15 EG-Konformitätserklärung
- 16 Urheberrecht
- 1 Introduction
- 2 Registering the device
- 3 Equipment and controls
- 4 Technical data
- 5 Safety
- 6 Start-up
- 7 Operation
- 8 Disassembling the drive
- 9 Towing/slipping the boat
- 10 Error messages
- 11 Care and service
- 12 General conditions of warranty
- 13 Accessories
- 14 Disposal and environment
- 15 EC Declaration of Conformity
- 16 Copyright
Start-up
EN DE
6 Start-up
6.1 Installation of the drive to the boat
CAUTION!
Danger of crushing when components are inserted!
Minor or moderately severe physical injuries may result.
■
Never put hands or fingers between the components.
ADVICE
Ensure that you have steady footing when installing the outboard. Connect the
tiller and the battery only after installing the drive onto the boat.
Outboard installation
1
Fig. 42: Transom clamp bolts
1
Transom clamp bolts
1. Place the outboard on the transom of the boat.
2. Fasten the outboard to the transom of the boat using the two transom clamp
bolts (1) and tighten the bolts.
3. Check that the outboard is fitted securely.
page 73 / 112