operation manual

57
DeutschEnglish
If the battery is not charged with the power supply provided (or other
Torqeedo products) please check the polarity of the connection. If the
polarity is not respected the device may be damaged and this is not
covered by the warranty
• IfyoudonotuseoriginalTorqeedoequipmenttochargeyourbattery
from the on-board battery supply, do ensure that the appropriate wire
diameters are used (fire hazards).
• Voltagesinexcessof60V(includingevenshort-termexcessvoltages)
can lead to damage of the battery.
5.4.5 Charging the batteries using solar energy
The battery can be charged directly using the Solar Charger SUNFOLD 50 (Torqeedo item
no. 1132-00).
It is also possible to charge the battery with solar panels with an open-circuit voltage of
up to 50V. For charging please use a wire cross-section of at least 0.5 mm
2
. In that case
the battery will dynamically adjust to the panel power.
Technical specifications for barrel connector and polarity: See chapter 5.4.4
• Alwayschargethebatteryunderthesupervisionofanadultandona
fire-resistant surface.
• Voltagesinexcessof60V(includingevenshort-termexcessvoltages)
can lead to damage of the battery.
5.4.6PowersupplytoadeviceviaUSBsupplyconnection
The adapter enclosed in the delivery allows power supply
to USB-compatible devices. Output voltage: 5V; maximum
output current: 1A.
Plug the adapter into the top of the charging socket and
tighten the union nut. Plug the USB-A plug connector of
your equipment into the adapter. The power supply to the
equipment will continue for four (4) hours after deactivation
of the tiller display. The charge coding for smartphones is
1A according to the Apple standard.
•Becarefulnottoapplyany(leverage)forcesontheadapter.
•PleasemakesurethatnowatergetsintotheUSBadapter.
•Whennotinuse,pleaseremovetheUSBadapter.