operation manual

51
DeutschEnglish
Usethe“setup”buttontosettheunitsforthedisplay:
First you can select the units in which the remaining range is displayed. Press the “cal“
button to switch between information in kilometers, statutory miles, nautical miles, and
hours.Youconrmyourselectionbypressing“setup”again.
You then enter the speed indicator setting. You can choose between kilometers per hour,
miles per hour, and knots. The selection is made again by pressing the “cal“ button. You
conrmyourselectionbypressing“setup”again.
Finally you select the battery information displayed. You can chose between charge sta-
tusinpercentandvoltage.Selecttheinformationtobedisplayedbypressingthe“cal”
buttonandconrmyourchoicebypressingthe“setup”buttonagain.Byconrmingyou
are leaving the setup menu.
The“cal”labelonthemiddlebuttonstandsfor“calibration”.Ifthedisplayshowsa
relevant error message you can recalibrate the tiller with the aid of this button. For details
please refer to the “Error messages/trouble shooting“ chapter.
Sample message in normal operation:
Battery charge status in percent
Remainingrangeatcurrentspeed
Speed over ground
Current consumption in Watt
Other messages:
Drive slowly: s displayed when the battery capacity is < 30%.
Charging: Is displayed when charging.
The GPS module integrated into the battery pack searches for sa-
tellite signals to determine the speed. If no GPS signal is received
the display switches in the second field from “remaining range
atcurrentspeed”(distance)to“remainingtimeatcurrentspeed”
(time). In addition, a clock icon is displayed.