Quick Start Manual

Manual Operations
Operating Programs Manually
Note: Watering programs (A, B and C)
can be operated individually or set to run
consecutively in alphabetical order.
1. Ensure the control dial is in the
run
position.
2. Position the
programs switch to select a
program you wish to start.
3. Press the
manual start button two times.
4. To place additional programs in queue,
repeat steps 2 and 3.
Note: When more than one program
is selected to start, the programs will
operate one at a time in alphabetical order
regardless of the order selected.
Manual Program Controls
Note: During automatic program operation,
the following manual controls are available:
w Pause Watering
Press the +/on and –/off buttons at the
same time.
w Resume Watering (when paused)
Press the next button.
w Cancel Watering
Press the +/on and –/off buttons at the
same time -
two times.
w Skip Zones
Press the next button one time.
w Adjust Zone Run Time
Press the +/on button to increase run time,
or the – /
off button to decrease run time.
13