Installation Instructions

ManualsBrandsToro ManualsCentral Control SystemsToro SitePro Central Control

Troubleshooting

If a malfunction occurs, follow the suggested steps to identify and fix the problem. If the problem cannot be resolved there

may be a problem with the FIU, the satellite or the DIU. If you have current NSN support, please call Toro NSN at 1-800-527-

4248. Otherwise, please call our

Toro Help Line, 1-800-664-4740 Monday through Friday, 7:30 AM – 4:00 PM (Pacific Time).

Field Interface Unit Specifications

Enclosure Dimensions: 5 3/8'' W x 7.5'' D x 13'' H (13.7 cm W x 19 cm D x 33 cm H)

Input: 12 V d.c., 1.5A (max.) Output: NEC Class 2 Fuse Protection: 1.5A (fast-blow)

Caution: For continued protection against risk of fire, replace only with the same type and rating of fuse.

Power Supply Input: 100–250V a.c., 50/60 Hz, 0.38A, +/- 10% Power Supply Output: 12 V d.c., 1.5A

Electromagnetic Compatibility

Domestic:

This equipment has been tested and found to comply with the limits for a FCC Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the

equipment in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instruction, may cause harmful interference to the radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does harmful interference to

radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

The user may find the following booklet prepared by the Federal Communications Commission helpful:

''How To Identify and Resolve Radio-TV Interference Problems''. This booklet is available form the U.S. Government Printing

Office, Washington, DC 20402. Stock No. 004-000-00345-4

International: This is a CISPR 22 Class B product.

“PC Connected – ” Light Off.

“FIU Active – ” Light Off

“FIU Ready” Light Off

“Processor Ready” Light Off

”Field Transmit” Light never turns On.

“Field Receive/Busy” Light never turns On.

1. FIU is not powered up.

2. Defective cable.

3. Defective FIU.

1. FIU is not powered up.

2. Defective cable.

3. Defective FIU.

1. SitePro is not downloaded prop-

erly and/or COM port driver

needs to be restarted/reloaded.

2. Bad processor or bad FIU.

1. Bad connection between modem

card and Serial Back Plane

(motherboard) inside the FIU.

2. Bad modem card.

1. Bad connection between FIU and

field satellite or DIU.

1. Apply power.

2. Replace cable.

3. Contact Toro distributor / NSN.

1. Apply power.

2. Replace cable.

3. Contact Toro distributor / NSN.

1. Restart SitePro program with FIU

COM port defined. Repeat sys-

tem setup procedure (see p.9).

2. Contact Toro distributor / NSN.

1. Contact Toro distributor / NSN.

2. Contact Toro distributor / NSN.

1. Contact Toro distributor / NSN.