System Guide

The General Alarms Tab

The Alarm example below indicates the exact time and date a power failure

occurred and when power was restored.

1. Choose the Power Failure notification check box as preferred.

2. Choose External Alarm check box to enable a satellite-monitored

peripheral sensor to notify Sentinel WMS when conditions occur outside

the specified operating parameters.

The Remote Output Alarms Tab

The Alarm information and options on this tab apply to the Sentinel Map to

Universal controller.

Note: The options for 2-wire decoder are not currently enabled.

1. Choose the station output check box associated with the alarm sensor.

2. Choose the

Send clear remote output alarms button to clear the alarm

condition and rearm the associated sensor.

The Current & User Set Alarms Tab

When a station current overload or output fault is detected, all affected

station numbers will be indicated on this Alarm tab. The current overload

condition will be indicated with a White highlight, and an output fault will

be highlighted in Red. Selecting User Set outputs will highlight the check box

in blue.

1. Choose the Clear all current & user alarms button to clear all checked

boxes.

2. Choose the associated check box for any station or output you wish to

monitor.

3. Choose the

Send current & user alarms button to update the satellite.

The Flow Alarms Tab

All under- and over- flow conditions will be indicated on this tab.

1. Choose the Send clear flow alarms button to clear and rearm the flow

sensor(s).