System Guide

3. The example below shows Soil Data Station and Station Mapping columns

hidden from view.

Note-EICON special-build wireless system only: The Setup Wireless,

and Learn Current buttons in addition to the Nominal and Actual Current

data column are applicable to EICON wireless communication system

setup only.

(Requires satellite firmware version 2.43 or higher.)

Using the Multi-Station Editor

The Zone Data column headings are organized within the Multi-Station

Editor panel. Station setup information is entered in the Editor text fields,

then transferred to a selected station or selected group of stations.

1. Choose Hide/Show Editor button on the Zone Data toolbar to display the

Multi-station Editor panel.

2. Enter a brief Station (Stn) Description and/or Type Description enabling

the station to be easily identified using the Station Search feature.

3. Choose the Station Type from the list-menu options. (Requires satellite

firmware version 1.41 or higher.)

4. Enter the Expected Flo

ate of the station.

Enter the Maxim

um Flow

ate

allo

wed for the station (alarm threshold).

6. Enter the

Plant Factor value from 0–255% (where 100% represents the

ET total value). (Required for ET-based run time calculations.)

7. Enter the Precipitation Rate value from 0–99.9 Inches/Hour.

(Required for ET-based run time calculations.)

8. Enter the Soil Infiltration Rate value from 0–99.9 Inches/Hour.

(Required for ET-based run time calculations.)

9. Enter the Water Holding Capacity value from 0–2.55 Inches.

10. Enter the

MapTo data Unit and Station numbers as applicable.

11. Using standard shift-click or ctrl-click keyboard commands, select all

station numbers to be edited simultaneously.

12. Edits can also be made for a specific column heading by dragging the

column heading box into the gray edit field as shown in the example

below.

Note: To revert to the default view, click and drag the column header out of

the gray field. Release the mouse button when the pointer changes to an X.

13. Identify the Editor column data to be transferred by selecting its check box.

The selected field color will change to yello

w as shown the example above.

14. Choose Apply Checked Columns button to transfer the data.