Owner's Manual

1# Sending this command will step from the currently operating station to
the next lower station number. As an example, if station 16 is currently
in operation and the 1# command is transmitted, station 16 will stop
and station 15 will initiate operation.
00# Sending this command will stop the satellite unit’s sequence operation.
Command Operation
#Cp# This command instructs the satellite to start a specified cluster
program. The C designates the cluster number, 1 for cluster A,
2 for cluster B, etc. The p designates the program number within
the specified cluster. As an example, if command # 24 # is transmitted,
cluster B program 4 will start.
#C3* This command instructs the satellite to stop the specified cluster in
operation. The C designates the cluster number (1 for cluster A,
2 for cluster B, etc.) to stop operation.
To set a field satellite unit for Secure mode operation, send ##CCC## command where CCC is the unit code. Press the
hand-held radio’s PTT button (Push To Talk) to transmit the command. Only the specified unit will respond to transmitted
commands. Send CCC ## to exit Secure mode operation. The field unit will displays S while in Secure mode.
Command Operation
CCC nn Station nn (where nn is the specified station) of unit CCC (where CCC
is the unit code)will irrigate for 30 minutes. After 30 minutes, the station
will stop irrigating and the satellite awaits for the next command.
CCC nn h tt Station nn of unit CCC will irrigate until the specified hour (h) and
minutes (tt) expire. As an example, entering 555 12 1 30 will energize
station 12 of unit 555 for 1 hour and 30 minutes.
CCC nn nn nn Use this command to turn-on multiple units for 30 minutes. The desired
satellite stations are listed in series after the unit number. As an
example, entering 555 12 13 14 will energize station 12–14 of unit 555.
CCC 3 Sending this command will step from the currently operating station to
the next higher station number. As an example, if station 16 of unit 555
is currently in operation and the 555 3 command is transmitted, station
16 will stop and station 17 will initiate operation.
CCC 1 Sending this command will step from the currently operating station to
the next lower station number. As an example, if station 16 of unit 555
is currently in operation and the 555 1 command is transmitted, station
16 will stop and station 15 will initiate operation.
CCC * Send a CCC * command to turn-off the last station that was turned-on.
If station 16 was the last station energized on unit 555 and a 555 *
command was transmitted, station 16 will stop operation.
CCC nn * Sending this command allows you to turn-off individual stations. As an
example, to turn-off station 16 of unit 555, send a 555 16 *.
CCC ** To turn-off multiple stations that are in operation within a specified unit,
send a CCC **, where CCC specifies the satellite unit.
CCC nn dd * Use this command to place a station in Rain OFF for a specified
number of days. Entering 555 16 05 * command will disable station 16
(nn) of Satellite unit 555 (CCC) for 5 (dd) days.
Secure Mode
Semi Auto Program Commands Under Normal Mode
A- 37
Toro Sentinel Central Software User’s Guide
Set sequence time.
Start sequence operation.
Action
Start cluster program.
Stop cluster program.
Action
Turn on station for 30 minutes.
Turn on a station for a
specified amount of time.
Turn on multiple stations.
Increment operation to the
next station.
Decrement operation to the
next station.
Turn off last station energized.
Turn off a specific station.
Turn off all stations in
operation within a satellite unit.
Place a station in Rain OFF.