Installation and Programming Guide
18
Set Program – Looping Start Time
The MC-E has the capability to loop a program. When a program is set to loop, the program will repeat after the loop
delay time is satised. The program will continue to repeat beginning from the start time until the designated end time.
To initiate the program to loop, you must assign a start time, end time and a loop delay to the program.
Set a Looping Start Time
Step 1 – Establish a start time to the program. (See Set Program – Program Start Time section.)
Step 2 – Assign a program End time. Turn the function dial to the SET PROGRAM position. Enter the program
number being modied. Enter
to access the loop function.
Enter the program end time in HH MM format and press . Use the button for PM.
Example: Enter 6:00am start time and 10:00pm end time.
Step 3 – Assign loop delay by entering
. Enter the delay time in H MM or MM and press .
Example: Assign a 30-minute loop delay. Enter
.
After establishing a loop, any additional program start time(s) will be deleted.
Step 4 – Return the Function dial to the Auto Run position to exit SET PROGRAM.