Installation and Programming Guide
15
Set Program – Program Start Time
Set Program Start Times
Each MC-E program can have up to eight start times.
Step 1 – Turn the Function dial to the SET PROGRAM position.
Step 2 – Enter the program number (1–8) being modied. Press to activate the selection.
Step 3 – Press the button to review all start times. Each programmed start times will be displayed momentarily
until the last start time is shown.
Step 4 – Enter the start time number (1–8) being created/modied and press the button. Enter the start time in
HH MM (Hours and Minutes) and press .
Enter HH MM
for PM time. (U.S. Time Mode)
The start time number will adjust according to the start time sequence. If assigning start time 4 with 6:00am
and currently, the earliest start time is at 7:30am, 6:00am will automatically become start time number 1 and
adjust the start time numbers accordingly.
Example: Assign 5:30am to start time number 1 for program 1 by entering 0530 .
The 05:55am time indicated on the display is the end time. This is calculated by adding the sum of all
the station runtimes and station delays to the start time.
If the assigned start time will result with an end time past midnight, the controller will Beep twice to indicate
that end time will run to the next watering day schedule.
The following screen will display momentarily:
Then followed by:
Step 5 – Return the Function dial to the Auto Run position to exit SET PROGRAM.