Installation and Programming Guide
14
Enter/Modify/Delete - Single or Multiple Stations
Step 1 – Turn the Function dial to the SET PROGRAM position.
Step 2 – Enter the program number (1–8) being modied. Press to activate the selection.
Step 3 – Enter the station number you want to create, modify or delete from the program and press the button.
Select multiple stations by entering the rst station number (two digits), then enter the last station in the
sequence (two digits) and press the button.
Entering a station number that is not assigned to the program will return a “No Runtime” message.
Step 4 – Assign the station runtime and press the button. If the station has a previous runtime, the newly entered
runtime will overwrite the previous value. Enter a runtime value of 0 minutes to delete.
Step 5 – Repeat Steps 3–4 to enter/modify/delete additional station(s) from the program.
Step 6 – Return the Function dial to the Auto Run position to exit SET PROGRAM.
Review Program Runtimes
Review the program’s cumulative runtime – Press the button once.
Review individual station’s runtime in the program – Press the button twice. The controller will sequentially scroll
through the program’s active stations along with their corresponding runtime.