Installation and Programming Guide

SETUP – Master Valve

Set Master Valve

As factory default, the Master valve is Enabled for all stations. The master valve will activate whenever a station

is activated.

In situations that a station does not require the master valve to activate, use the following procedure to select the station

and Disable or Enable the master valve.

Step 1 – Turn the Function dial to the SETUP position.

Step 2 – Press the button. The following display will be shown on the screen.

Step 3 – Press the or buttons to select the station number you want to edit. Use the or button to

toggle MV (Master Valve) from ON or OFF.

Step 4 – Repeat Step 3 for additional stations.

Step 5 – Return the Function dial to the Auto Run position to exit SETUP.