Installation and Programming Guide

11
SETUP – Event Days
The MC-E allows you to pre-program ten event days throughout the year. During an event day, the controller will suspend
automatic watering. Event days will reoccur every year unless deleted.
Example: If December 25 is set as an event day, the controller will ignore watering every December 25 of each year until
it is deleted from the Event Days.
Set Event Day:
Step 1 – Turn the Function dial to the SETUP position.
Step 2 – Press the button. The screen will display the following:
Press the button to review the day off events or enter new events. The screen will display the following:
Use the or button to review the programmed events.
Step 3 – Enter the Event number (1–10), then press the button.
MC-E will re-number the event day if the newly created event is out of sequence or if an event is
deleted.
Step 4 – Enter the Month and Date (MM DD) of the event day being programmed and press the button. When
the controller is in International mode, enter the Date rst before the Month (DD MM). The controller will
increment the total event day and display the following:
Step 5 – Repeat Steps 2–3 for additional event days.
Step 6 – To delete an event, scroll through the event number to select it. Once the event is displayed,
enter and press the button to delete.
Step 7 – Return the Function dial to the Auto Run position to exit SETUP.