Installation Manual

Paths – 1
234
Valve Box
Maximum communication wire length
between the controller and the farthest
decoder is 15,000ft (4500m).
Recommended Cable for Controller-to-Decoder
is the Paige
®
P7350D, 14 AWG, Solid Copper,
Jacketed 2-Conductor, Direct Burial cable.
White
Black White
Black
White
Black
White
Black
The maximum communication wire length between the decoder
module and the solenoid is 410ft (125m).
Recommended Cable for Decoder-to-Solenoid is the Paige
®
P7351D, 14 AWG, Solid Copper, 2-Conductor, Direct Burial cable.
To easily identify stations for
troubleshooting, install wires with the same
color code as the station wires.
Output Board
White Power/Communication Wire
Black Power/Communication Wire
Station 1
Solid Red Station Wire - Connect to the Red/White solenoid wire
Red with Black Stripe
Station Wire - Connect to the Black solenoid wire
Station 2
Solid Green Station Wire - Connect to the Red/White solenoid wire
Green with Black Stripe Station Wire - Connect to the Black solenoid wire
Station 3
Solid Orange Station Wire - Connect to the Red/White solenoid wire
Orange with Black Stripe
Station Wire - Connect to the Black solenoid wire
Station 4
Solid Blue Station Wire - Connect to the Red/White solenoid wire
Blue with Black Stripe
Station Wire - Connect to the Black solenoid wire
Figure 4
Each station can activate up
to two DC Latching Solenoids.
Out to additional
decoder modules
Station Wires
The GDC output board can
accommodate up to 100 stations.
The decoder modules can be
connected in any configuration
using the four station terminals.
1-Station
Decoder
Module
When possible, install
the decoder module in a valve
box for ease of service.
DC Latching
Solenoid
Red
Black