Installation Manual

11
Update Time
is is the time at which the sensor will update the controller
with new ET data. If irrigation were to commence at 6am, for
example, it might be advantageous to have ET data sent to the
controller at 5:45am to optimize watering runtimes.
1. Press or to adjust the hour, minute, and AM/
PM elds.
2. Press or to switch from one eld to another.
3. Press to input the value.
Average % Days
is is the previous number of days from which the sensor
will use to generate an average runtime value. is is done to
minimize the impact of unseasonably cold or hot days. Values
range from 1-7 (days).
1. Press or to change the number of days.
2. Press to input the value.
My Location
Setting the My Location is necessary for ET data to work. It
is possible to set the location by either U.S. ZIP Code or by
Latitude and Longitude. (See Step 7 illustration, page 6.)
1. To adjust TYPE, press to move to ZIP CODE.
Press to select LONG/LATor ZIP CODE.
2. Press . Adjust Zip Code or Latitude and Longitude
values with the and buttons.
Use and to switch between number elds.
3. When done, move to CONTINUE. Press .
After a moment, the screen should display SUCCESS.
Signal Strength
Indicates signal strength as a series of bars ( ).
AVERAGE % DAYS
ID
MY LOCATION
SIGNAL STRENGTH
BATTERY LEVEL GOOD
WEATHER SENSOR
→
MY LOCATION
Battery Level
Displays the charge level of the battery in the weather sensor.
(See above illustration.)