User's Guide

Early models of the Irritrol MC-E “Blue”, need the CMR-

ADP cabler. The 5-pin connector is sandwiched between the

front panel and the circuit board in the lower right hand corner.

Attach the cable adapter to the controller with the black wire

up. Later models have an RJ connector in the same location.

Orient the cable adapter with the black wire up for the

MC-E “Blue” controller. (Later models have the RJ socket.)

The “Manual Program” feature does not work with MC-

E controllers. A remotely started program runs continuously.

The KwikDial controller requires the CMR-ADP cable adapter

to attach its 5-Pin connector to the mini-receiver. Attach the

cable adapter to the controller with the blue wire up. The other

end of the cable adapter has the female socket for the RJ jack.

Orient the cable adapter with the blue wire up for the

KwikDial controller.