Introduction “The vitriol Climate Logic™ wireless weather sensor system transforms your automatic irrigation control system into a immunodeficiency, water thesaurus management center Compatible with remote-ready Irritation and Toto controllers, Climate Logic automatically regulates watering duration parascending 1 real time weather conditions and specific geographic and focal weather profile information provided on a specification Setup Catch in addition, integral ii aid freeze sensing further reduce wastef
Step 6 — Press and hold the sensor Test Pin for 10-15 seconds to activate the Weather Sensor! A red LED {viewable through the lower vent ring) will illuminate twice after 10 seconds to confirm activation (if not already active). See page 9. Step 7 Press the sensor Test Pin again to confirm signal reception at the Receiver Module. The CLIMATE LOGIC: receiver's red LED will turn on momentarily when the signal is received.
~ Weather Sensor Test Pin Pressed to simulate rain sensor operation and test communication. 2 ~ Rain Sensor Adjustment Cap Adjusts Rain Sensor threshold toa nominal setting of 1/8”, 1/4”, 1/2” or 3/4” {3 mm, 6mm, accumulated rainfall. 3 Solar Collector Collects and measures solar radiation. Requires full exposure to sunlight 4 Battery Compartment & Factory-installed 9-Alkaline battery can sustain normal Weather Sensor operations up to five years.
. The Receiver Module will automatically* synchronize time and date with the hast controller upon initial power-up. SER ee i “Note: Does not apply to TIC-212 controller. Mal in Menu, © 5. Verify that the time and date are synchronized correctly. Location Remote If necessary, adjust the Receiver Module as follows: : Setup Utility Nate: The display will automatically return to the Home screen if aka is not pressed within 60 seconds.
A Important: The Climate Logic Weather Sensor is shipped with the battery circuit deactivated. To initially activate the sensor prior to installation, press and hold the Test Pin for 10-15 seconds. A red LED, viewable from the lower vert area, will illuminate twice after 10 seconds (if not already active). Note: The Weather Sensor and Receiver Module are paired for wireless communication from the factory. The following procedure wolf only be required if Please Add Sensor is displayed on the Home screen. 1.
3. The Climate Logic system is designed to provide effective wireless communication in most applications. Loss of range can result from interference in the signal path. To verify signal reception from the selected installation site, perform the following test: + Start a manual watering operation of a zone that can be seen from the installation site. Press and hold the Sensor Test Pin. If the signal is received, watering should shut off within a short time.
a The following Setup features are accessed through the ET Setup menu (MENU = SETUP <» ENTER). ET Setup us Alf setup parameters are selected, adjusted and entered using the Auto Program Adjust A NEXT/BACK, €33 /€5) and SAVE keys. Restrictive NONE Auto Program Adjust: In all cases, Climate Logic regulates the Water Ra strict Time) 0.0 o run time of all stations assigned to Program A.
Default (DEFAULT => ENTER): The Default utility feature enables all user-defined setup parameters to be either erased and reset to the factory default settings, or a complete system reset including Location, History, and Sensor Pairing. * « Press the YES key to reset to the Factory Default settings. . Factory Defaults? o See Default settings listed on page 12. » Press the NO key to return to the previous screen. » Press the ERASE key to display the Erase All prompt screen.
The Climate Logic system tracks and records the dally adjust Climate LOGIC% men factor for a rallying, two-year period. A one-month snapped shot Is represented by the small bar graph on the Home screen. . Ne Rain. irrigation The graph is updated daily, and builds from the left to right, 0s a Go with the mast recent day appearing on the left of the scale. Gi MENU 54 Pressing the % key displays the Water History graph ina large-scale format.
= The Receiver Module and irrigation controller must remain synchronized for proper operation of Climate Logic system operations. The Timer option of the Main Menu provides the utility features that enable synchronization to be easily verified and updated as needed « From the Home screen, select the Main Menu, Timer option {MENU TIMER ENTER). The controller make, model and software version will be displayed. « Crass the REFRESH key as needed to update the controller VITRIOL Rain Dial formation.
Weather Sensor/Transmitter, Model CL-W Receiver Module, Model C1-M19 275"W x 57H x 6.25" D {over bracket) « Compatible with Remote-ready vitriol and Toto 7 emW x 127 cm Hx 15.6 cm D (over bracket) Controllers and CL Series Handheld Remote + input Power (from controller: Sv DC + LOD Screen Dimensions: 25"Wx 1.25" H B35emWx318cmH » LCD Contrast Adjustment + Battery: 9-Alkaline, up to 5-year duration » Antenna Wire 1.51. x 0.192 Dia, 3.81 cmb x 4.8 mm Dia. + RF Reception Range: Up to 10007 (304 my LOS : \ » Op
