Installation Instructions

TOPDRESSER 1800 MOUNTING BASE
(92-4351)
PRODUCT: TOPDRESSER 1800 MODEL 44220
SUBJECT: Prevention of mounting base twist due to improper dump cylinder connection to the
Workman vehicle.
SITUATION: When attaching the Topdresser 1800 to the Workman vehicle dump cylinders, the
correct mounting hole must be used on each side of the topdresser. When installing on a
Workman with a serial number below 60101, use mounting hole "A" on each side. When installing
on a Workman with a serial number 60101 and above, use mounting hole "B" on each side.
Failure to use the same hole on each side will cause the unit to twist. This condition will cause
the unit to crack from excessive frame stress.
©
The TORO Company - 1996
All Rights Reserved
"B"
"A"
MOUNTING HOLE "A"
MOUNTING HOLE "B"