Reference Guide

Revision 1 03-01-2021 Toro Form No 3445-725 Rev A
Perform the necessary maintenance procedures as specified in the following tables (for complete procedures, refer to the Operator’s Manual):
Tool Inspection Process
Step
Action
1
Clean grass clippings and dirt from under the machine.
2
Remove the deck drive covers and clean grass clippings.
3
Check the condition of the deck belts and pulley bearings.
4
Check the hydraulic pump-drive belt.
5
Clean the engine screen and engine-oil cooler.
6
Check the safety-interlock system.
7
Grease the front caster pivots.
8
Check the seat belt.
9
Check the roll-bar knobs.
Tool Rental Center
Spring Maintenance Guide
Z Master Commercial 3000 Series Riding Mower
Model No. 74949—400000000 and Up
Model No.
74949HD—400000000 and Up
Supplier Technical Support #:
800-888-9926 (US and Canada)
Supplier Website: www.Toro.com
PURPOSE
Follow the directions below to maintain this tool.
SAFETY
Refer to the product Operator’s Manual for complete safety information.