Setup Instructions

Figure 6
1. Seat
3. Switch harness
2. Seat switch
6. Lo w er the seat and adjust it if necessar y; refer
to P ositioning the Seat in the mo w er Operator’ s
Manual .
Step
4
Installing the Motion
Control Levers
Parts needed for this step:
2
Control lever
4
Bolt (1/4 x 3/4 inch)
Procedure
1. P osition the control lev er to the desired height
and align with the holes in the control lev er
shaft ( Figure 7 ).
2. Install 2 bolts (1/4 x 3/4 inc h) into the control
lev er and shaft ( Figure 7 ).
Figure 7
1. Control lever
3.
2. Bolt
3. R e peat the installation for the opposite control
lev er .
4. Lo w er the seat and adjust if necessar y; refer to
P ositioning the Control Lev ers in the Operator’ s
Manual .
Step
5
Completing the Setup
Parts needed for this step:
1
Ignition Key
1
Operator’s Manual
1
Engine Operator’s Manual
1
Hose coupling
Procedure
Checking the Tir e Pr essur e
Chec k the front and rear tires for proper inflation.
R efer to Chec king the Tire Pressure in the Operator’ s
Manual for the recommended inflation pressure .
Checking the Mo w er Adjustment
T he mo w er dec k w as lev eled at the factor y . If the
mo w er is not cutting lev el, adjust the side-to-side
lev el and the front-to-rear blade slope . See the
Operator’ s Man ual for the proper procedure .
Checking the Side Discharge Chute
R emo v e the pac king restraint holding the side
disc harg e c hute up and lo w er the c hute into place .
Checking the Engine Oil Lev el
4