FORM NO. 3319-716 ( CLASSIC GARDEN TRACTOR TOR, pr 300 SERIES INSTRUCTIONS Loose Parts Note: Use the chart below to identify parts for assembly. 3 DESCRIPTION Front Wheel Assemblies Shim Washer ~ 3/4 x thick Shim Washer — 3/4 x .
Set-Up Instructions DESCRIPTION QTy. USE Hairpin Cotter ~ 1 5 Attaching accessory to lift bar, Flat Washer Operator's Manual 1 Read before operating tractor. Set Up Instructions 1 Read before setting up tractor Riding Mower Safety Video 1 View before operating tractor Installing the Front Wheels Install the front wheels onto the spindles with the valve stems facing inward (Fig 1). Install one 3/4 x hubcap washer onto cache spindle, then insert the cotter pin into the hole in the spindle (Fig. 1}.
Installing the Rear Wheels 1. Remove the wheel bolts holding the rear shipping brackets to the rear hubs. 2. Install the wheels onto the hub with the valve stems facing inward. Secure each with (5) 7/16 x 3/4” wheel bolts (Fig. 2). 3. Torque the wheel bolts to 75-80 ft-In (105-112 Eminem. 1278 Figure 2 3. Wheel Bolt (8) x 54° 1. Hub 2. Rear Wheel Checking the Tire Pressure Check the front and rear tire pressure. The correct front and rear tire pressure is 12 psi (83 kappa.
Set-Up Instructions Activating the Bakery 2. Remove the filler caps from the battery. Slowly pour electrolyte into each cell until the electrolyte level is up to the Tower part of the DANG tube (Fig. 4). Use an electrolyte with a specific gravity of 1,263, POTENTIAL HAZARD + Battery electrolyte contains sulfuric acid which is a deadly poison and it causes severe burns. WHAT CAN HAPPEN o If you carelessly drink electrolyte you could die or if it gets onto your skin you will be burned.
Set-Up Instructions 5. Slowly pour electrolyte into each cell until the level is once again up to the “UPPER” line on the battery case (Fig. 4), then install the filler A\ WARNING POTENTIAL HAZARD caps. # Charging battery produces gasses. 6. Install the battery in the tractor and connect the de. battery cables. (Refer to the Operator’s Manual — * Installing the Battery.) HOW TO AVOID THE HAZARD o Keep cigarettes, sparks and flames away Nate: Do not ran the tractor with the battery from battery.
Set-Up Instructions Installing the Seat 1. Install the shoulder bolts and large LD. spacers into the rear holes in the seat (Fig. 6). 2. Position the seat onto the seat base by inserting the two shoulder bolts through the keyhole openings in the seat base slots, Make sure the 3/8 x spacers are positioned between the seat and the seat base (Fig. 6). 3. Locate the 11732 x 17 spacers between the seat and seat base, then thread the hand knobs and 11/32 x 17 flat washers into the front holes in the seat (Fig.
Sat-Up Instructions Checking the Wiring and 5 Fasteners Inspect the tractor for any loose electrical connections and secure as required. Check the wire routing to make sure e moving parts interfere with the wires to cause a short. Check all fasteners to make sure they're tight. Test Driving the Tractor 1. 2 Check the oil level in the crankcase. Refer to the Operator’s Manual for oil type, viscosity and crankcase capacity.
