FORM NO. 3319–901 Power Sweept Blower Model No.
Safety IMPORTANT SAFETY INSTRUCTIONS • Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. • DRESS PROPERLY. Do not wear loose clothing or jewelry. Pin up long hair. Be aware of the position of the blower and the air inlets during operation. Loose clothing, jewelry and hair can be drawn into the inlets (Fig. 1) and may result in personal injury. Always wear substantial footwear and long pants.
Read operator’s manual Electrical shock/electrocution Consult technical manual for proper service procedures Disconnect power Do not open or remove safety shields while engine is running Severing of fingers or hand—impeller blade Wear eye protection Assembly Note: Blower is shipped with inlet cover installed. Note: Refer to Figures section at the back of the manual. Note: Always turn off unit and unplug from electrical outlet before adding or switching attachments.
Before Starting Operation This appliance is intended for residential use only. Securing Extension Cord Use only an extension cord recommended for outdoor use. POTENTIAL HAZARD • Debris can be thrown by unit in operator’s or bystander’s direction. WHAT CAN HAPPEN • Flying debris can cause serious personal injury to operator or bystanders. HOW TO AVOID THE HAZARD • Always wear safety goggles or other suitable eye protection, long pants and shoes while operating unit.
Troubleshooting PROBLEM Unit won’t run or stops running Unit seems to be low on power POSSIBLE CAUSE CORRECTIVE ACTION 1. Unit not plugged in 1. Plug in unit 2. On/off switch in “off” position 2. Turn to “on” 3. Inlet cover or vacuum tube incorrectly installed or removed 3. Secure cover or vacuum tube 4. Blown fuse or tripped circuit breaker 4. Replace fuse or reset breaker 5. Faulty extension cord 5. Replace cord 1. Impeller is worn 1.
TORO AUSTRALIA POWER EQUIPMENT WARRANTY Subject to the warranty condition below, this tool (hereinafter called “the product”) is warranted by Toro Australia (hereinafter called “the Company”) to be free from defects in material or workmanship for a period of 24 months from the date of original purchase covering both parts and labour. Under the terms of this warranty, the repair or replacement of any part shall be the opinion of the Company or its authorised agent.
Figures 1 1 4 7 1 2 1 2 1. Model and serial number decal m-4027 1601 1. Pointers aligned in lock postion 2. Air inlet 1990 1. Switch 2 3 2 5 4 1 1 1571 1. Blower tube 2. Blower housing outlet 3 3. Tab 4. Latch 2 1 m-4003 1. Cord lock 3 6 4 1. Inlet cover 2. Housing pointer 1596 3. Cover pointer 4. Tab 1 1989 1.
