Operator's Manual

Replacing Line

F or re placement line , purc hase a new , pre-w ound spool of line

(model no . 88175) or bulk line (0.065 inc h dia. (1.6 mm) x 30ft.

(9 m)) that y ou can wind onto the old spool. Both are a v ailable

from y our A uthorized T oro Dealer .

Metal wir e, r ope, plastic kni v es, or an y material other than

T or o .065 inch dia. (1.6 mm) n ylon monoﬁlament may

o v er load the motor , possibl y causing a ﬁr e or electrical

shock.

Do not use an y material other than T or o .065 inch dia.

(1.6 mm) n ylon monoﬁlament, 30 ft. (9 m) maximum line

length.

Removing the Spool

1. T wist the cap off countercloc kwise ( Figure 12 ).

Figure 12

2. R emo v e the cap and spool ( Figure 13 ).

Note: If the spring falls off , install it before installing the

spool.

Figure 13

3. T horoughly clean the cutting head and cap and inspect them

for any damag ed or w or n par ts .

Rewinding the Spool

Note: If y ou are re placing the spool with a new , pre-w ound

spool, discard the empty spool and skip this section.

1. R emo v e any cutting line left on the spool.

2. Hook one end of line all the w ay into the slot on the spool

( Figure 14 ), allo wing no mor e than 1/8 inch (3 mm) to

pr otr ude.

Figure 14

3. Wind the line in the direction of the ar ro w on the spool, in

lev el ro ws , betw een the spool ﬂang es .

Important: T he trimmer will not function cor r ectl y if

y ou wind the line in the wr ong dir ection, the end of the

line pr otr udes mor e than 1/8 inch (3 mm), or y ou wind

mor e than 30 ft (9 m) of line on the spool.

Installing the Spool

If y ou do not full y install the spool and cap , the trimmer

could thr o w them during operation, causing injur y to y ou

or bystander s.

1. Holding the line and spool, inser t the spool into the cutting

head and the line into the eyelet ( Figure 15 ).

Figure 15

2. Holding the line and spool, place the cap o v er the spool

( Figure 16 ).

Figure 16

3. T wist the cap on securely cloc kwise ( Figure 17 ).

Figure 17