Form No. 3355–111 Rev C Sulky Line Painter 1200 Model No. 42023—260000001 and Up Operator’s Manual Register your product at www.Toro.com.
Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . General Operation . . . . . . . . . . . . . . . . . . . . . . . . Setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Loose Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installing the Sulky Hitch . . . . . . . . . . . . . . . . . . . Installing the Sulky . . . . . . . . . . . . . . . . . . . . .
Safety Improper use or maintenance by the operator or owner can result in injury. To reduce the potential for injury, comply with the safety instructions in the Line Painter operator’s manual and always pay attention to the safety alert symbol, which means CAUTION, WARNING, or DANGER—“personal safety instruction.” Failure to comply with the instruction may result in personal injury or death. General Operation • Do not modify the sulky or use it on non–approved machines.
Setup Loose Parts Description Qty. Sulky hitch Carriage bolt, 5/16 x 4–1/2 in. Capscrew, 3/8 x 4 in. Washer, .406 x .813 Locknut, 5/16 in. Locknut, 3/8 in. 1 Washer, .813 x .563 2 Lynch pin 1 Operator’s Manual 1 Parts Catalog 1 Use 4 2 2 Installing the sulky hitch 4 2 Installing the Sulky Hitch Installing the sulky to the hitch 4. Install (2) 5/16 x 4–1/2 in. carriage bolts in place of the old bolts (Fig. 2). 1. Park the line painter on a flat, clean surface.
8. Remove the jack stands, install the wheels and lower the line painter to the floor. Installing the Sulky 1. Apply a light coating of oil to the unpainted portion of the sulky pivot shaft (Fig. 4). 1 Figure 4 1. Pivot shaft 1 2. Insert a .813 x 1.563 washer onto the pivot shaft (Fig. 5). Figure 3 3. Insert the pivot shaft into the sulky hitch and secure with a .813 x 1.563 washer and a lynch pin (Fig. 5). 1. Hitch 4 2 3 2 1 Figure 5 1. Sulky pivot shaft 2. Washer 3.
Operation • Drive slowly and take time to learn how the sulky moves when using it for the first time. • Use care when turning to ensure that you do not swing yourself and the sulky into obstacles. • When turning, lean forward and toward the direction of the turn to help in keeping your balance.
Maintenance Recommended Maintenance Schedule Maintenance Service Interval Maintenance Procedure 8 hours • Check the tire pressure 25 hours • Grease all fittings • Oil pivot shaft • Grease all fittings • Check the tire pressure • Paint chipped surfaces Storage Service Checking Tire Pressure Oil the Pivot Shaft Ensure that the caster wheel tires are filled with air to 18–20 psi (124–138 kPa) every 8 operating hours or before each use.
The Toro General Commercial Products Warranty A Two-Year Limited Warranty Conditions and Products Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Commercial Product (“Product”) to be free from defects in materials or workmanship for two years or 1500 operational hours*, whichever occurs first.
