FORM NO. 95-2454 OPERATOR'S MODEL NO. 41552-60101 & UP MANUAL L PA-17 SPREADER &MOUNTING KIT J for use on the MULTI-PRO® 5500 A The safety alert symbol means CAUTION, WARNING, or DANGER — personal safety instruction. Allure to comply with the instruction may result in personal injury.
A\ SAFETY INSTRUCTIONS MAINTENANCE: 9. Keep all nuts, hols and other fasteners tightened securely. Replace any shields removed 8. Before servicing or making any adjustments during servicing or adjustments. to the Spreader: 10. To be sure of optimum performance and A. Stop the vehicle and set the parking safely, always purchase genuine TOR brake. replacement parts and accessories. Replacement parts and accessories made by other B. Disengage all power and wail until all manufacturers could be dangerous.
CONTROLS FLOW CONTROL HANDLE: Opens and closes the regulator disc in the Ho per opening, 1o start or stop the flow of material. Pull the Han die forward, toward the operator, 1o open the regulator disc. Push the Han die back, away from the operator, to close the regulator disc. FLOW REGULATOR: Determines the rate at which the material flows from the Hopper. The highest number setting (7) on the regulator Scale, indicates the largest opening, for maximum flow of material.
CONTROLS FIG. 3 1. Stop Pin 2. Calibration Spacer A\ DANGER ROTATING MEMBERS CAN CAUSE SERIOUS INJURY! Before making any adjustments or repairs on the Spreader: « Stop the Vehicle and set the Parking Brake. = Shut off the Vehicle’s engine and remove the Ignition Key. » Pull the Directional Control Valve DOWN to disengage the Spreader drive. SPOUT ARC SETTING: The embossed plus and minus ‘" signs on the Spreader housing, indicate the operating arc of the Spreader Spout.
CONTROLS SPREADER CALIBRATION To calibrate the TOR Spreader you must determine the desired rate of flow for the material being applied (in pounds per acre), as specified by the material’s manufacturer. To achieve this application rate, first establish the following: 1. The spread width infest, for the material being applied. NOTE: This width will vary depending on the density of the material and the Spout arc setting. 2. Flow rate of material from the Hopper, in pounds per acre.
OPERATING INSTRUCTIONS Refer io the charts on page 5 as guidelines to determine the Spout Arc and Flow Regulator settings to achieve the desired rate of application for the material being used. 1. Position the Stop Pin (and Calibration Spacer it necessary) to stop the Flow Control Handle at the desired setting on the Regulator Scale, as described on page 3. 2. Choose the appropriate Spreader Spout and position the Arc Adjuster as needed for the application rate required, as described on page 5. 3.
The Toto Promise A One Year Limited Warranty The Toto Company promises to repair your Model 41150 PA-17 Spreader and Model 41562 Mounting Kit for the Multi-pro® 5500 Vehicle if defective in materials or workmanship. The following time stipends from the date of purchase apply specie warranty tens, on certain components, may be offered through The Tore Company by the component manufacturers: Commercial YR The cost of parts, labor and transportation are included.
