Installation Instructions

14
20.Apply thread sealer and install (2) 1 Ball Valves
into opposing ports of 1 Cross using (2) 1 Close
Nipples. See FIG 16.
21.Apply thread sealer and install a 1 x 3/4 Hose
Barb in the end of both Ball Valves.
22. Apply thread sealer and install 1 x 90° Barbed
Elbow in the top port of the Cross.
23.Apply thread sealer and install a 1 x 3/4 Hose
Barb in the bottom port of the Cross.
24. Mount Cross Base to Boom Frame using (1)
5/16 x 3/4 carriage bolt and flange nut. See FIG.
16.
IMPORTANT! DO NOT overtighten U-Bolts in
step 25. The clamping action could crush the
Cross.
25. Mount Cross Assembly to Cross Base, as
shown in FIG. 16, using (2) 5/16 U-Bolts and (4)
flange nuts.
26.Attach other end of the 1 x 64 Hose attached
to Ratchet Valve earlier to the 90° Hose Barb in
top of Cross. Secure with (1) 1 hose clamp.
NOTE: When cutting the hoses for the Extension
Booms be sure to leave enough hose length to
cross Booms.
27.Attach a 3/4 x 50 hose to L.H. Ball Valve and
secure with hose clamp. Route hose under Spacer
Tube between Boom Frame and Boom Mount
toward L.H. Extension Boom. See FIG. 12 & 16.
Mark Hose and cut to proper length. Attach hose
to Double Barb Turret on inside of L.H. Extension
Boom using hose clamp. See FIG 15. Repeat for
R.H. Extension Boom.
28.Attach a 3/4 x 50 hose to Hose Barb in
bottom of Cross. Route to 90° Hose Barb at R.H.
end of Center Boom Pipe. (See FIG. 13) Mark
Hose and cut to proper length. Attach hose to
90° Hose Barb using hose clamp.
29.Connect closed end of Turnbuckle to the Lug
& Chain using (1) Lap Link. Secure by squeezing
Lap Link closed. See FIG. 17.
30.Attach lug on Turnbuckle Assembly to Boom
Mount Assembly using (1) 1/2 flange nut. Hook
other end under Cargo Bed frame and tighten
securely.
31. Repeat steps 29 & 30 for opposite Boom Mount
Assembly
FIG. 16
1. 1 Ball Valve 3. Cross Base
2. 1 Cross
2
1
3
1
1221
1
2
3
FIG. 17
1. Lug & Chain 3. Turnbuckle
2. Lap Link
1263