FORM NO. 92-8323 MODEL NO. 41420-40001 & UP L TOP DRESSER 5000 J NOTE: "Right*, “Left", “Front" and "Rear are referenced while seated in the operators position. ELECTRIC CONTROL BOX: Select a convenient, flat surface on your Tractor's right hand fender to mount the Mounting Bracket which will hold the Electric Control Box. See FIG. 1. NOTE: When mounting the Bracket on Tractors with ‘round® fenders, it may be necessary fo place shims between the Bracket and the fender, to create a fiat, level surface. FG.
BRAKE SWITCH: The Brake Switch is o be installed so that when the towing Tractor's brakes are disengaged, the button on the Switch is depressed approximately 1/8 inch. When the Tractor's brakes are engaged, the Switch button must be released for it’s full length. 1. Use the Brake Pedal Lock io lock the towing Tractor's Brake Pedals together. See FIG. 3. TRACTOR WITH ROUND BRAKE ARM SHOWN FG. 3 1. Brake Lock 8. Brake Arms 2. Brake Switch {Found) 2.
7. Route the Brake Switch Wiring Ha mess from the Control! Box, through hole in Tractor's fiver plate, along the Brake Arm and connect it to the Brake Switch. See FIG. 5. 5 3. Brake Switch 4. Plastic Tie 1. Wiring Ha mess 2. Brake Arm {IMPORTANT! Be especially careful when routing the Wiring Ha mess fo prevent the Wiring from coming into contact with any _sharp edges or "pinch® points. 8. Secure the Wiring Harness to the Brake Arm with plastic ties provided. TO CHECK THE BRAKE SWITCH INSTALLATION: 1.
