Installation Instructions

1
COMPRESSOR ASSEMBLY:
1. Assemble the Compressor complete as
shown on page 4.
IMPORTANT! Make sure the brass check valve
is installed in the Tee on top of the Compressor.
MODEL NO. 41417-200000101& UP
SET-UP AND
PARTS LIST
FOAM MARKER KIT
for the SKID SPRAYER
Refer to the illustrated Parts List for the details of parts used in assembling the Foam Marker Kit.
FIG. 1
1. Mounting Angle
NOTE: If installing this Kit on a vehicle equipped
with "Enclosed Boom," work these instructions
with the "Enclosed Boom" Instructions found in
the Set-up and Parts manual.
"Right" and "Left" as used in the following
instructions, refer to the operator's right and
left when seated in the normal operating
position. Likewise, "Front" and "Rear" as seen
from the operator's position.
1655
1656
1. Attach the Mounting Angle to the lug on the
Skid Frame as shown in FIG. 1. Secure with two
5/16" x 1" hex hd. cap screws, flat washers, lock
washers and hex nuts.
male bullet terminal provided. Crimp the other
male bullet terminal to the red Compressor wire.
3. Remove a panel from the Compressor Box and
secure the Compressor to the Plate and the Box
with three #8 x 1/2" hex hd. cap screws and lock
washers.
4. Insert the rubber Grommet into the hole in the
bottom of the box.
5. Route the 37" Air Supply Hose up through the
Grommet and attach it to the barbed elbow on top
of the Compressor. Secure with a hose clamp.
6. Route the Compressor wires through the
Grommet.
2. Remove the ring terminal from the black
Compressor wire, strip the wire and crimp on the
2. Brass Check Valve
3. Male Bullet Terminal
4. Compressor Box
FIG. 2
1. Compressor
5. Reinforcement Plate
6. Grommet
7. Air Supply Hose
©The TORO Company - 2000
All Rights Reserved
FORM NO. 92-0400 REV. A