FORM NO, 83-6272 . OPERATOR'S ']DR MODEL NO. 41413 MANUAL HIGH PRESSURE PUMP KIT for the SKID SPRAYER To assure maximum safety, optimum A The safety alert symbol means CAUTION, performance, and to gain knowledge of the wanna, or DANGER — personal safety product, It is essential that you or any other instruction. Failure to comply with the operator of this equipment read and instruction may result in personal injury. understand the contents of this manual before the vehicle engine is ever started.
SAFETY INSTRUCTIONS MAINTENANCE: When the Diaphragm (high pressure Pump System isotope b% use(d: Secure the Sprayer Hand Gun and Hose before sta ing the Pump, The highly pressurized discharge of stingray solution may cause a “whipping” action, causing personal injury and for property damage. B. Check hoses for weak or worn condition before each use. Make sure that all connections are tight and secure: €. Make sure there are no restrictions in the hoses serving the Diaphragm Pump.
SAFETY AND INSTRUCTION DECALS The following safety and instruction decals are installed with the High Pressure Pump Kit. If any become damaged or illegible, replace them. Decals and part numbers are listed below and in the parts catalog. Order replacements from your Authorized Toto Distributor. IMPORTANT BEFORE STARTING RNl HAVE VALVES SET CENTRIFUGAL Pump OPERATION R " ron DIAPHRAGM i LT Part Mo, 82-0239: Located an the Skid Sprayer Frame, near Centrifugal Pump.
CONTROLS {IDLER ENGAGEMENT CHAIN: Used to bring the idler Pulley into contact with the Drive Belt, creating tension to allow the engine to drive the selected pump system. DO NOT DISENGAGE THE BELT WHILE THE ENGINE IS RUNNING! NOTE: For the sake of clarity, the safety shields have been removed in this illustration. NEVER operate the Sprayer with the Brit Cover or the Belt Shield removed! FIG. 1 1. Diaphragm Pump 3. idler Engagement {High Pressure) Chain 2. Idler Pulley 4, Drive Belt FiG. 2 1.
CONTROLS FiG. 3 1. High Pressure Valve 3, Pressure Relief/ {Closed) Adjustment Valve 2. Pressure Gauge {Open} PRESSURE CONTROL UNIT: Controls the operating pressure and flow of spray solution. A. High Pressure Valve: Opens and closes to contra the supply of spray solution to the Hand Spray Gun. See FIG. 3. B. Pressure Relief/Adjustment Naive: Controls the operational pressure of the spray system. Raise the lever to relieve the pressure in the stern.
3. OPEN the Suction Line Valve and CLOSE the Agitator Valve. Position the Directional Valve Lever as shown in FIG. § FIG. 8 3. Directional Valve 1. Suction Line Valve {Pen) (High Pressure} 2. Agitator Valve 4. Pressure He fief/ {Closed) Adjustment Naive IMPORTANT! Be certain the Suction Line Valve is open and liquid has reached the Pump before the Pump is activated. The Pump will be DAMAGED if it is allowed to run dry! 4. Fill the Tank with clean, clear water.
MAINTENANCE A warning @ Before servicing or making adjustments to the Skid Sprayer, stop the transport vehicle and set the parking brake. Shut off the Diaphragm Pump engine, @ Pull wire off the spark plug to prevent the engine from being started. A warning Fluids under high pressure can cause severe Injury.
The Toto Promise A One Year Limited Warranty The Toto Company promises to repair your Motel 41413 High Pressure Pump for the Skid Sprayer if defective in materials or workmanship. The following time periods from the date of purchase apply special warranty terms, on certain components, may be offered through The Toto Company by the component manufacturers: Commercial Products The cost of parts, labor and transportation are included.
