Operator's Manual

2
4. Before backing up, look to the rear and assure
no one is behind. Back up slowly.
5. Watch out for traffic when near or crossing
roads. Always yield the right of way to pedestrians
and other vehicles.
6. If equipment begins to vibrate abnormally, stop
immediately. Shut off the vehicle engine and
disengage all power. Repair all damage before
commencing operation.
7. Before servicing or making any adjustments to
the Sprayer:
SAFETY INSTRUCTIONS
3. Keep all shields, safety devices and decals in
place. If a shield, safety device or decal is
malfunctioning, illegible or damaged, repair or
replace it before operating the machine.
4. Chemicals can injure persons, animals, plants,
soils or other property. To eliminate environmental
damage and personal injury:
5. Drive the Vehicle slowly.
WHILE OPERATING:
1. DO NOT OVERLOAD THE VEHICLE. Failure
to position loads carefully can result in their shifting
or tipping over. Distribute loads evenly, keeping
them as low as possible to prevent them from
becoming too top-heavy.
2. Make certain everyone is clear of the machine
before starting the engine to move the vehicle or to
engage the sprayer pump drive.
3. This attachment adds extra height to the vehicle
when the booms are in the raised position. Drive
the vehicle safely:
A. Select the proper chemical for the job.
B. Follow manufacturers instructions on
chemical container labels. Apply and handle
chemicals as recommended.
C. Handle and apply chemicals with care.
Wear goggles and other necessary protective
equipment. Handle chemicals in well ventilated
areas. Never smoke while handling chemicals.
D. Properly dispose of chemical container and
unused chemicals.
A. Stop the vehicle and set the parking brake.
B. Shut off the vehicles engine and remove
key from ignition.
C. Disengage all power and wait until all moving
parts have stopped.
D. In order to avoid electric shock, inspect the
area overhead for wires before raising booms.
E. Always use caution while operating the
booms near low clearance areas.
8. Keep all nuts, bolts and other fasteners tightened
securely. Replace any shields removed during
servicing or adjustments.
9. To assure optimum performance and continued
safety of this product, always use genuine TORO
replacement parts and accessories. Replacement
parts and accessories made by other
manufacturers may affect the product's operation,
performance or durability. Such use could also void
the warranty of The Toro Company.
A. Always SLOW the vehicle when
approaching and while making a turn.
B. Always SLOW the Vehicle when driving
in unfamiliar areas or over rough terrain.
C. Always SLOW the Vehicle when
changing direction of travel or preparing to
stop.
D. When turning or driving on slopes,
always SLOW the Vehicle, then turn the
Vehicle to prevent loss of control and
possible upset.
E. DO NOT make sudden or sharp turns.
DO NOT suddenly change direction of
travel on an incline, ramp, grade, slope or
similiar surface.
F. Always adjust the vehicle speed to allow
for existing conditions such as wet, slick
surfaces, low visibility, etc.
G. Be especially careful when driving a
heavily loaded vehicle down an incline or
slope. Drive the vehicle UP and DOWN the
face of the slopes, inclines or grades.
whenever possible. DO NOT DRIVE across
the face if at all possible. There is a risk of
upsetting the vehicle, which can result in
serious injury or death.