Quick Start Guide

4.Presstheregiontypeicon,andselecta
categorizedregion,workregion,excluderegion,
ordisabled.
5.Pressthecategoryiconandselectapreset
categoryorcreateanewcategory.
6.Pressthegreencheckboxicon
g294821
Figure8
1.Selecttheboundarywith
yournger
5.Categoryicon
2.Boundary6.Deletethecategoryicon
3.Editboundarymenu
7.Nameofboundaryicon
4.Deletetheboundaryicon
CreatingaProductand
TankVolume
Note:Ensurethattheunitsarecorrectforyouruse;
refertoSelectingtheCorrectUnitsofMeasureinthe
GeoLinkOperator’sManual.
1.Fillthesprayertankwithcleanwater.
2.Pressthesprayer-ratecontrollericonand
expandtheratecontrollerminiview(Figure9).
3.Presstheselectproducticon.
4.Inthepop-upwindow,presstheproductname
icon,andselectaprogrammedproductoranew
product.
5.Pressingthenewproductandgreencheckbox
iconsbeginthenewproductsetupwizard.
6.Inthenewproductsetupwindow,pressthe
customproductandrightarrowicons.
7.Pressproductnameicon,typethenewproduct
namewiththepop-upkeyboardwindow,press
thegreencheckboxiconandthentheright
arrowicon.
8.Presstherateincrementsicon,typeamountthat
youwanttoincrementtheapplicationrate,and
pressthegreencheckboxicon.
9.Presstheproductrate1or2icons,type
applicationratefortheproduct,andpressthe
greencheckboxiconandthentherightarrow
icon.
10.Inthesaveproductsettingpop-upwindow,
pressthegreencheckboxicon.
11.Inthelltankpopupwindow,presstheyesorno
icontoselectthenewproductforsprayertank.
g294540
Figure9
1.Spray-ratecontrollericon
4.Productnameicon
2.Expandicon
5.Newproduct(setup)icon
3.Selectproducticon
SprayingaBoundary
1.Pressthejobiconattherightsideofthescreen
(Figure11).
2.Pressthenameforthejob(Figure11).
Note:Forthe1750sprayersonly,runthe
valve-balancewizardbeforeselectinganozzle.
3.Pressthecorrectnozzle(Figure12).
4.ExpandtheAutoSectionControl(ASC)
CongurationscreenandpressASCON(Figure
13).
5.Selecttheworkregion(Figure10)thatyouare
spraying(i.e.fairways,greens,tees,etc.).
6.Selecttheexcludedregion(s)thatyouarenot
spraying(bunkers,trees,hazards,etc.),as
showninFigure10.
g294469
Figure10
1.Selecttheworkregions2.Selecttheexcluded
regions
7.Pressthemasterswitchicon(MultiPro5800
only).
3