MODEL NO. 41150-20101 & UP FORM NO.
spreader controls Familiarize yourself with the controls and recommended operating procedures, before actually operating the Spreader. CLUTCH CONTROL HANDLE is the ON/OFF contra for the Spreader. Push the Handle DOWN to engage the Agitator and Spreader Spout mechanisms. Pull the Handle UPF toward the operator, to disengage the mechanisms and stop the Agitator and Spreader Spout action. FLOW CONTROL HANDLE: Opens and closes the regulator disc in the Hopper opening, to start or stop the flow of material.
spreader operation SPREADER CALIBRATION: To calibrate the HAHN Spreader you must determine the desired ate of the material being applied (in pounds pex ace, as specified by the material manufacturer. To achieve this application rate, first establish the following: #® Spread width in feet, for the material being applied, NOTE: This width will vary according to density of material and the Spout arc setting. ® Flow rate of material from the Hopper, in pounds per minute.
USE THE FOLLOWING CHART AS A GUIDELINE ONLY, TO DETERMINE A FLOW REGULATOR SETTING TO APPROXIMATE THE APPLICATION RATE DESIRED. Due io weather conditions and variances in density, moisture content and particle size . . . flow rates will nof always be the same as those Shawn.
