Operator's Manual

6
3351-836 Rev A
Product Overview
1
2
3
4
5
8
6
7
9
m-6230
1. Discharge chute
2. Chute crank
3. Control bar
4. Handle
5. Control panel
6. Knobs
7. Handle bolt (2)
8. Rotor blades
9. Fuel tank cap
1
2
3
4
5
6
mĆ5544
1. Key switch
2. Primer
3. Electric-start button
4. Recoil start
5. Cord connection
6. Choke lever
Setup
Installing the Handle
1. Cut the plastic tie that secures the control cable
to the handle.
Note: Hold the cable taut to ensure that it stays
connected at the bottom.
2. Position the upper handle as shown.
mĆ5516
3. Loosely
install the handle
bolts, curved
washers, and
knobs as shown.
mĆ5573a
4. Hook the end
of the control
cable into the
bottom hole of
the control bar.
m-5519
5. Fully insert the handle bolts.
Important:
Ensure that you
do not pinch the
control cable.
6. Tighten the
knobs until they
are snug.
m-6104a
7. Adjust the control cable. Refer to Adjusting the
Control Cable on page 11.