Operator's Manual

3. Hook the end of the control cable spring into the
bottom hole of the control bar (Figure 4).
G001116
Figure 4
4. Fully insert the handle bo lts (Figure 5).
Important: Ensure that you do not pinch the
control cable (Figure 5).
G001117
Figure 5
5. Tighten the knobs u ntil they are snug.
6. Adjust the control cable. Refer to Adjusting the Control
Cable.
2. Install
ing the Discharge
Chute
Install the discharge chute as shown (Figure 6).
G001118
Figure 6
Product Overview
6
G001114
1
2
3
4
5
7
8
9
Figure 7
1. Discharge chute 6. Knobs
2. Chute handle
7. Handle bolt (2)
3. Contr
ol bar
8. Rotor
blades
4. Handle 9. Fuel tank cap
5. Control panel
6