Installation Instructions

1
All Rights Reserved
Printed in the USA
W 2006 by The Toro Company
8111 Lyndale Avenue South
Bloomington, MN 55420-1196
Auxiliary Hydraulic Power Kit
Groundsmaster
)
7200/7210 Traction Units
Model No. 30380
Form No. 3356–247 Rev A
Installation Instructions
Note: The Auxiliary Hydraulic Power Kit is used in
conjunction with the Rear Quick Attach System, Model
30377.
1. Locate the manifold block mounted to the rear quick
attach system adapter bracket (Fig. 1).
1
2
2
2
2
Figure 1
1. Manifold block 2. Plug
2. From the side of the manifold block, remove the (3)
plugs shown in figure 1.
3. Install the straight fittings, male coupler, female coupler
and quick disconnect coupler to the manifold block
(Fig. 2).
Note: Make sure the O–rings are in position and lubricated
before installing the fittings.
4. Install the dust cap and dust plugs to the appropriate
couplers (Fig. 2).
5. Remove the plug from the top of the manifold block
(Fig. 1).
6. Thread the cartridge valve into the manifold block
(Fig. 2).
1
2
4
5
7
3
5
6
1
1
Figure 2
1. Straight fitting
2. Male coupler
3. Female coupler
4. Quick disconnect coupler
5. Dust plug
6. Dust cap
7. Cartridge valve
7. Locate the control panel knock–out plug under the rear
quick attach system decal (Fig. 3). Remove the
knock–out plug and cut away the decal from the
opening.
1
Figure 3
1. Knock–out plug location
8. Under the control panel, locate the connector from the
rear quick attach system wire harness.
9. Plug the connector into the included switch and plug the
switch into the control panel.