Form No. 3396-375 Rev B Trench Filler Compact Utility Loader Model No. 22472—Serial No. 315000001 and Up Register at www.Toro.com.
This product complies with all relevant European directives. For details, please see the Declaration of Incorporation (DOI) at the back of this publication. This manual identifies potential hazards and has safety messages identified by the safety-alert symbol (Figure 2), which signals a hazard that may cause serious injury or death if you do not follow the recommended precautions.
Safety WARNING When the engine is off, attachments in the raised position can gradually lower. Someone nearby may be pinned or injured by the attachment as it lowers. Improper use or maintenance by the operator or owner can result in injury. To reduce the potential for injury, comply with these safety instructions and those in the traction unit Operator's Manual. Always pay attention to the safety-alert symbol, which means Caution, Warning, or Danger—personal safety instruction.
• Look behind and use care when backing up with the CAUTION Hydraulic couplers, hydraulic lines/valves, and hydraulic fluid may be hot and can burn you if you touch them. • Wear gloves when operating the hydraulic couplers. • Allow the traction unit to cool before touching hydraulic components. • Do not touch hydraulic fluid spills. • • • • • General Trench Filler Safety The following instructions have been adapted from the ANSI/OPEI and ISO standards.
Safety and Instructional Decals replacement parts and accessories. Replacement parts and accessories made by other manufacturers could be dangerous, and such use could void the product warranty. • Always transport the trench filler in a lowered position. Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or lost.
Product Overview 1 2 3 4 g013187 decal107-9378 g013187 107–9378 1. For more information read the Operator’s Manual. 5 Figure 3 2. Keep the center arrow on the trench filler attachment decal centered over the trench when operating. 1. Float guide 4. Bearing 2. Hydraulic lines 5. Skid (2) 3. Auger Specifications Note: Specifications and design are subject to change without notice.
Operating Tips Operation • Clean the area of trash, branches, and rocks before trench Refer to your traction unit Operator’s Manual for more information on installing and removing attachments on your traction unit. filling to prevent equipment damage. • For best trench filling, center the unit over the trench (Figure 4). Important: Always use the traction unit to lift and move the attachment. Filling a Trench 1. Put the key into the ignition switch and turn the key to the ON position. 2.
Maintenance Recommended Maintenance Schedule(s) Maintenance Service Interval Before each use or daily Maintenance Procedure • Check the bolts and nuts securing the auger. • Grease the auger bearing. Every 200 hours Yearly or before storage • Adjust the skids. • Paint chipped surfaces. CAUTION If you leave the key in the traction unit ignition switch, someone could accidently start the engine and seriously injure you or other bystanders.
Storage 1. Before long term storage, wash the attachment with mild detergent and water to remove dirt and grime. 2. Grease the auger bearings. 3. Check and tighten all bolts, nuts, and screws. Repair or replace any damaged or worn parts. 4. Ensure that all hydraulic couplers are connected together to prevent contamination of the hydraulic system. 5. Paint all scratched or bare metal surfaces. Paint is available from your Authorized Service Dealer. 6.
Troubleshooting Problem The attachment does not operate. Possible Cause Corrective Action 1. A hydraulic coupler is not completely connected. 1. Check and tighten all couplers. 2. A hydraulic coupler is damaged. 2. Check the couplers and replace any that are damaged. 3. Find and remove the obstruction. 3. There is an obstruction in a hydraulic hose. 4. A hydraulic hose is kinked. 5. The auxiliary valve on the traction unit is not opening. 10 4. Replace the kinked hose. 5. Repair the valve.
Notes:
Notes:
Notes:
Declaration of Incorporation Model No. 22472 Serial No. Product Description Invoice Description General Description Directive 315000001 and Up Trench Filler, Compact Utility Loader TRENCH FILLER ATTACHMENT CE Compact Utility Loader 2006/42/EC Relevant technical documentation has been compiled as required per Part B of Annex VII of 2006/42/EC. We will undertake to transmit, in response to requests by national authorities, relevant information on this partly completed machinery.
International Distributor List Distributor: Agrolanc Kft Asian American Industrial (AAI) B-Ray Corporation Brisa Goods LLC Casco Sales Company Ceres S.A. CSSC Turf Equipment (pvt) Ltd. Cyril Johnston & Co. Cyril Johnston & Co. Fat Dragon Femco S.A. FIVEMANS New-Tech Co., Ltd ForGarder OU G.Y.K. Company Ltd. Geomechaniki of Athens Golf international Turizm Hako Ground and Garden Hako Ground and Garden Hayter Limited (U.K.) Hydroturf Int. Co Dubai Hydroturf Egypt LLC Irrimac Irrigation Products Int'l Pvt Ltd.
Toro Compact Utility Equipment Warranty Compact Utility Equipment (CUE) Products A One-Year Limited Warranty Conditions and Products Covered Items and Conditions Not Covered The Toro Company and its affiliate, Toro Warranty Company, pursuant to an agreement between them, jointly warrant your Toro Compact Utility Equipment (“Product”) to be free from defects in materials or workmanship.
