Installation Instructions

The T oro Company – 1999
8111 Lyndale Ave. South
Bloomington, MN 55420–1196
All Rights Reserved
Printed in the USA
Form No. 3323-285
Model 22442
Cement Mixer Bowl
For use with the Siteworks Systems Auger Drive Head
Installation
Instructions
IMPORTANT: Befor e using this pr oduct, read the
safety section in your traction unit operator ’ s manual,
and follow all pr ecautions listed ther e.
Safety Decals
# 100–4664
1
2
Figure 1
1. Tipping hazard—do not
exceed the maximum load
2. Maximum load
Specifications:
Note: Specifications and design are subject to change
without notice.
Overall width 25.15 inches (64 cm)
Overall length 18.25 inches (46 cm)
Weight 75 lbs (34 Kg)
Maximum dry concrete
load
200 lbs (90.7 Kg)
Stability Ratings
To determine the degree of slope you can traverse with the
cement bowl installed on a traction unit, find the stability
rating for the hill position you want to travel in the
appropriate table on the following page, then find the
degree of slope for the same rating and hill position in the
Stability Data section of the traction unit operator ’s
manual.
IMPORTANT
: If your traction unit has a r ear
operator’
s platform, the counterweight must be used
on the platform while using the cement bowl, or the
traction unit will become unstable.
WARNING
POTENTIAL HAZARD
• Exceeding the maximum r ecommended slope
can cause the traction unit to tip.
WHA T CAN HAPPEN
• If the traction unit tips, you or bystanders could
be crushed.
HOW T O A V OID THE HAZARD
• Do not drive the traction unit on a slope steeper
than the maximum r ecommended slope, as
determined in the following tables and the
traction unit operator ’ s manual.