FORM NO. 3321–220 Over–the–Tire Tracks Model No. 22431 Operator’s Manual IMPORTANT: Read this manual carefully. It contains information about your safety and the safety of others. Also become familiar with the controls and their proper use before you operate the product.
Introduction We want you to be completely satisfied with your new product, so feel free to contact your local Authorized Service Dealer for help with service, genuine replacement parts, or other information you may require. Whenever you contact your Authorized Service Dealer or the factory, always know the model number of your product. This number will help the Service Dealer or Service Representative provide exact information about your specific product.
Contents Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safe Operating Practices . . . . . . . . . . . . . . Slope Chart . . . . . . . . . . . . . . . . . . . . . . . . . Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . General Specifications: . . . . . . . . . . . . . . . Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Loose Parts . . . . . . . . . . . . . . . . . . . . . . . . . Preparing the Traction Unit . . . . . . . . . . . .
Safety Improper use or maintenance by the operator or owner can result in injury. To reduce the potential for injury, comply with these safety instructions and always pay attention to the safety alert symbol, which means CAUTION, WARNING, or DANGER—“personal safety instruction.” Failure to comply with the instruction may result in personal injury or death. Safe Operating Practices General Operation 1.
Safety • Follow the manufacturer’s recommendations for wheel weight or counterweights to improve stability. • Use only Toro approved attachments. Attachments can change the stability and the operating characteristics of the machine. Warranty may be voided if used with un–approved attachments. • Keep all movement on slopes slow and gradual. Do not make sudden changes in speed or direction. 18. Use extra care when loading or unloading the machine onto a trailer or truck. • 19.
Safety Children Tragic accidents can occur if the operator is not alert to the presence of children. Children are often attracted to the machine and the work activity. Never assume that children will remain where you last saw them. The following requirements must be followed to prevent injury to children. 1. Keep children out of the work area and under the watchful care of another responsible adult. 2. Be alert and turn the machine off if children enter the area. 3.
Safety Slope Chart Read all safety instructions on pages 2–4.
Specifications General Specifications: Overall width 4 inches (10.1 cm) Overall length 89 inches (226 cm) Weight (per track) Track thickness Note: 6 144 lbs (65.3 Kg) 0.250 inches (6.3 mm) Specifications and design are subject to change without notice.
Installation Loose Parts DESCRIPTION QTY. Wheel spacers 4 Lug nuts (20 provided with the wheel spacers and 20 on the traction unit) 40 Over–the–tire track assembly 2 Bolt 4 Locknut 4 Warranty Registration Card 1 Operator’s Manual 1 USE Install on wheels Install on traction unit Read before use Preparing the Traction Unit Installing the Tracks 1. Put the traction unit up on blocks and remove the wheels. 1. Lay one track on a level surface. 2. 2.
Installation 5. Repeat steps 1 through 4 for the other side of the traction unit. 6. Drive the traction unit for a few minutes to loosen the tracks. 7. Lay a long, straight bar across the top of each track. There should be 1” to 3” of slack in the top span of the track below the bar (Fig. 3). 1 Removing the Tracks 1. Stop the traction unit so that one of the bolted connector links on a track is in the middle of the top span. 2.
Maintenance Service Interval Chart Service Operation Each Use 5 Hours Track tension—check and adjust 25 Hours 200 Storage Hours Service Notes X POTENTIAL HAZARD • If you leave the key in the ignition switch, someone could start the engine. WHAT CAN HAPPEN • Accidental starting of the engine could seriously injure you or other bystanders. HOW TO AVOID THE HAZARD • Remove the key from the ignition switch before you do any maintenance.
Maintenance 3. Check the track tension and repeat steps 1 and 2 for one of the other adjustable track sections if additional tensioning is required. Storage 1. Before long term storage, wash the traction unit with mild detergent and water to remove dirt and grime from the entire machine. 2. Check the condition of the tracks and tighten all bolts and nuts. Repair or replace any part that is damaged or worn. 3. Paint all scratched or bare metal surfaces.
" (+( #- (+$ 2,- &, +( . - #' ' + #&#- ++ '-2 " (+( (&) '2 0 ++ '-, 2(.+ (+( #- (+$ 2,- &, +( . - 3 +( . - -( + +(& -, #' & - +# %, (+ 0(+$& ',"#) (+ -" ) +#( ( -#& %#,- %(0 " + 0 ++ '- % (' #-#(' 1#,-, (+( 0#%% + ) #+ -" +( . - - '( (,- -( 2(. #' %. #'! # !'(,#, % (+ ) +-, ' -+ ',)(+- -#(' "#, 0 ++ '-2 !#', (' -" - -" +( . - #, %#/ + -( -" (+#!#' % + - #% ).+ " , + ++ '-2 .+ -#(' ' 2 + (+ () + -#(' % "(.
