Form No. 3351-159 3 cu. ft. Narrow Bucket for Dingo TX 413 Compact Utility Loader Model No.
Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Safety Decal . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Maximum Material Density at Capacity . . . . . . . Stability Ratings . . . . . . . . . . . . . . . . . . . . . . . . . . Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Specifications Warning Note: Specifications and design are subject to change without notice. When going up or down hill, the machine could overturn if the heavy end is toward the downhill side, possibly pinning or seriously injuring you or bystanders. Operate up and down slopes with the heavy end of the machine uphill. An attached auger bit will make the front end heavy. Caution If the bucket is not kept level while lifting, the load could be inadvertently dumped on the operator, causing injury.
Material Density Chart Material Caliche Stability Ratings Density (Loose) 78lb/ft3 (1250 kg/m3) Warning 104 lb/ft3 (1660 kg/m3) Exceeding the maximum slope can cause the traction unit to tip. If the traction unit tips, you or bystanders could be crushed. Clay: Natural bed Dry 93 lb/ft3 (1490 kg/m3) Wet 104 lb/ft3 (1660 kg/m3) With gravel, dry 89 lb/ft3 (1420 kg/m3) With gravel, wet 96 lb/ft3 (1540 kg/m3) Do not drive the the traction unit on a slope steeper that the maximum slope.
Stability with a Loaded Bucket Orientation Front Uphill Rear Uphill Side Uphill Operation Stability Rating Operating Tips B When loading material, always have the bucket level to the ground, moving forward into the material. When the bucket is full, tilt it gently rearward to decrease the lifting resistance when you lift the load. When transporting a load, keep the bucket as close to the ground as possible. D Storage 1.
