Form No. 3374-417 Rev B CE Kit STX-26 Stump Grinder Model No. 22368 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure 1 2 3 4 © 2012—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420 Description Brake bar Locknut Mounting link Flange-head shoulder bolt Idler spring Flange-head nut (8 mm) Flange-head nut (9.
1 Installing the Parking Brake Parts needed for this procedure: 1 Brake bar 2 Locknut 1 Mounting link 1 Flange-head shoulder bolt 1 Idler spring 1. Tensioning bolt 2 Flange-head nut (8 mm) 2. Jam nut 2 Flange-head nut (9.5 mm) 1 Long bolt 1 Shoulder bolt 3 Hex nut 1 Threaded rod 1 Brake yoke 1 Brake plate 1 Brake handle 1 Hex head shoulder bolt 1 Hex socket/hex head shoulder bolt 1 Handle grip Figure 1 3. Clamp bolts 5. Loosen the clamp bolts (Figure 1). 6.
B. Remove the bolt and gasket from the center of the wheel and pull the wheel off of the machine. 1 5 3 4 5 2 8. Remove the track, beginning at the top of the front road wheel, peel it off of the wheel while rotating the track forwards. 9. Repeat step 7 to remove the inside, rear road wheel. Installing the Brake 1. Remove the bottom shield. 2. Line up the brake bar with the slots located behind the tracks and slide the bar through from right to left. 3.
7. Install the bottom shield. 8. Tighten the jam nut. 9. Tighten the clamp bolts and torque to 75 ft-lb (102 N-m). 2 10. Lower the machine to the ground. Adjusting the Hydraulic Hoses Installing the Interlock Rod The hydraulic hoses under the control panel above the brake lever need to be oriented so that the 45 degree elbow in the hose fitting points to the right as shown in Figure 6. If they are not, loosen the hose fittings and orient and torque them as shown in Figure 6.
1 2 1 G018759 2 Figure 8 1. Bolts 2. Hydraulic motor cover G018841 4 Figure 9 1. Decal 107-8495 Applying the Decals Parts needed for this procedure: 1 Decal 107-8495 1 Decal 121-4438 Procedure 1. Clean the area where the decals will be placed and ensure that it is free of dirt, grease, or other foreign material. 2. Remove the backing of the decals and place them carefully on the unit as shown in Figure 9. 5 2.
Notes: 6
Notes: 7
