Setup Instructions

ManualsBrandsToro ManualsCompact LoaderToro 22362

Printed in the USA

 2003 by The Toro Company

8111 Lyndale Avenue South

Bloomington, MN 55420-1196

CE Kit

Dingo



TX Compact Utility Loader

Model No. 22362

Form No. 3327–723

Installation Instructions

Loose Parts

Note: Use the chart below to identify parts for assembly.

Description Qty. Use

Traction decal, 104-9952

Danger decal, 104-9957

Auxiliary decal, 104-9955

Control panel decal, 104-9956

Danger decal, 93-7814

Pinch decal, 100-8821

No rider decal, 100-8822

Caution decal, 104-9950

Caution decal, 104-9951

Danger decal, 104-9954

LWA decal,105–7895

CE information decal, 22306, 104-9981

CE information decal, 22307, 104-9984

Brake decal, 104-9958

Interlock decal, 104-9977

Loader decal, 104-9953

Installing the CE decals

Fuel cap 1 Replacing the fuel cap

Hot surface plate, 104-9983

Pop rivet

Replacing the hot surface plate

Hood latch cover

Carriage bolt

Locknut

Installing the hood latch cover

Operator’s Manual

1 Replace the

Operator’s Manual

Installing the Decals

Install the CE decals over the English decals on the

traction unit as shown in the tables on the following

pages.

Install each decal as follows:

1. Thoroughly clean the area where you will install the

decal.

2. Dampen the area with water or mildly soapy water.

3. Peel the decal from the backing and install it in place.

4. Squeegee across the surface of the decal, starting at the

center of the decal and working toward the edges using

overlapping strokes.

Summary of content (4 pages)

PAGE 1
Form No. 3327–723 CE Kit Dingo TX Compact Utility Loader Model No. 22362 Installation Instructions Loose Parts Note: Use the chart below to identify parts for assembly. Description Qty.
PAGE 2
Location US English CE 100-2842 (US English) On console 104-9956 (CE) 100-6140 (US English) On rear safety plate 104-9957 (CE) On the loader arm 100-6101 104-9951 100-6132 104-9950 100-6135 104-9954 Between the loader arms On the cylinder lock 2
PAGE 3
Location US English CE 100-6136 104-9955 100-6138 104-9952 80-8040 93-7814 104-2837 104-9953 104-2838 104-9958 104-2844 104-9977 No equivalent 104-9981 On the console On console Under the hood on the frame On console On console On console Model 22306 only: place to the right of the serial decal under the hood.
PAGE 4
Location US English CE Model 22307 only: place to the right of the serial decal under the hood. No equivalent 104-9984 No equivalent 105-7895 Place on the outside right frame, under the pivot pin of the loader arm. Replacing the Hot Surface Plate Location US English CE 80-8290 104-9983 On the front frame 1. Using a 1/8 in. (3 mm) drill bit, drill out the centers of the rivets securing the US English version of the hot surface plate on the front of the heat shield. 3 4 2.