Installation Instructions

ManualsBrandsToro ManualsVehiclesFuel Pump Bracket Kit, Workman HDX-D Utility Vehicle with Bed

FormNo.3396-173RevA

FuelPumpBracketKit

Workman

HDX-DUtilityVehiclewithBed

ModelNo.132-6702

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCaliforniato

causecancer,birthdefects,orreproductiveharm.

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Removetheexistingbracket.

Fuel-pumpbracket1

Spacer

Bolt(M8)

J-clip1

Installthekit.

RemovingtheExistingBracket

1.Movethemachinetoalevelsurfaceandsettheparking

brake.

2.RaisethebedandinstallthebedsupportOperator’s

Manualforthemachine.

3.Shutofftheengineandremovethekeyfromthe

ignitionswitch.

4.Disconnectthefuellinesfromthefuelpump.

5.RemovetheexistingJ-clipfromtheclutch-cable

bracket(Figure1).

Note:Retainthebolt(M8x20).

Figure1

1.Bolt(M8x20)3.Clutch-cablebracket

2.J-clip

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3396-173*A

Summary of content (2 pages)

PAGE 1
Form No. 3396-173 Rev A Fuel Pump Bracket Kit Workman® HDX-D Utility Vehicle with Bed Model No. 132-6702 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Remove the existing bracket.
PAGE 2
3. Insert the fuel pump into the fuel-pump bracket (Figure 4). 6. Remove the fuel pump from the fuel-pump bracket (Figure 2) Figure 2 1. Fuel pump 3. Bolt (M8 x 20) 2. Fuel-pump bracket 4. Transaxle assembly Figure 4 7. Remove the existing fuel-pump bracket from the transaxle assembly (Figure 2). 1. Fuel pump 4. Existing bolt (M8 x 20) 2. Bolt (M8 x 35) 5. Fuel-pump bracket 3. Spacer Note: Retain 1 bolt (M8 x 20). 4.