Installation Instructions

ManualsBrandsToro ManualsAttachmentsSide Mirror Kit, Workman HD/HDX/HDX-D Utility Vehicle

FormNo.3420-698RevA

SideMirrorKit

Workman

HD/HDX/HDX-DUtilityVehicle

ModelNo.115-7849

InstallationInstructions

WARNING

CALIFORNIA

Proposition65Warning

ThisproductcontainsachemicalorchemicalsknowntotheStateofCalifornia

tocausecancer,birthdefects,orreproductiveharm.

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Uppermirrorbracket1

Lowermirrorbracket1

Mirrormount1

Bolt(5/16x3/4inch)

Flangenut(5/16inch)

Mirror1

Pan-headscrew(1/4x1inch)

Nutinsert4

Installthesidemirrorkit(formachineswithoutacanopy

installed).

Mirrormount1

Bolt(5/16x1-1/2inches)

Flangenut(5/16inch)

Installthesidemirrorkit(formachineswithacanopy

installed).

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.Engagetheparkingbrake.

3.Shutofftheengineandremovethekey.

g038494

Figure1

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3420-698*A

Summary of content (4 pages)

PAGE 1
Form No. 3420-698 Rev A Side Mirror Kit Workman® HD/HDX/HDX-D Utility Vehicle Model No. 115-7849 Installation Instructions WARNING CALIFORNIA Proposition 65 Warning This product contains a chemical or chemicals known to the State of California to cause cancer, birth defects, or reproductive harm. Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty.
PAGE 2
Installing the Side Mirror Kit Ensure that the lower mirror bracket is contacting the side of the machine. For Machines without a Canopy Installed 1. To install a mirror on the left side of the machine (driver’s side), measure 4.45 cm (1-3/4 inches) out from the edge of the dash panel, and draw a parallel line to the edge (Figure 2). g010820 Figure 4 If a 4-post ROPS is installed on the machine, measure 5.1 cm (2 inches) instead of 4.45 cm (1-3/4 inches). 4.
PAGE 3
Installing the Side Mirror Kit For Machines with a Canopy Installed 1. g010823 Figure 7 8. Remove the screws securing the upper mirror bracket to the dash and remove the mounts. 9. Install a nut insert into each of the drilled holes (Figure 8). Locate the windshield mounting holes in the front canopy support tubes (Figure 10). g010824 Figure 8 1. Upper mirror bracket 3. Nut insert 2. Pan-head screw (1/4 x 1 inch) 10.
PAGE 4
. Position the mirror mount onto the tube, aligning the top hole with the new hole in the tube (Figure 11). 7. Secure the mirror to the mirror mount using the supplied screw and washer (Figure 13). g011855 Figure 13 g011853 Figure 11 1. Mirror mount 1. Mirror 2. Washer 5. Using the mirror mount as a template, locate, mark, and drill the lower 8.3 mm (5/16 inch) diameter hole through both walls of the tube (Figure 11). 8. 6.