Installation Instructions

FormNo.3381-622RevA

UpperROPSFrameKit

LT3340,CT2120,CT2140,CT2240,orGroundsmaster

3400

TractionUnit

ModelNo.111-7251

InstallationInstructions

Introduction

ThisproductcomplieswithallrelevantEuropeandirectives.

Fordetails,pleaseseetheDeclarationofIncorporation(DOI)

atthebackofthispublication.

Carefullyreadandunderstandtheinformationinthismanual

tolearnhowtotthehooptoyourproductproperlyand

avoidinjuryandproductdamage.Refertoyourtraction

unitoperatormanualforinformationonsageuseand

maintenanceoftheROPS.

Thisrollbarmustonlybeusedtoreplaceexistingrollbar

fromtractionunitsttedwiththeROPScomplyingwith

SafetyStandardISO21299.

Ifafterstudyingthismanualyouareunsurehowtotthiskit,

alwaysseekprofessionaladvicefromyourlocalauthorised

dealer

Wheneveryouneedservice,genuineToroparts,oradditional

information,contactanAuthorizedToroDistributororToro

CustomerServiceandhavethemodelandserialnumbers

ofyourproductready.

Specications

Weightofrollbar22.5kg(49.6lbs)

Heightofmachine2.160m(7.08ft)

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.Toro.com.

OriginalInstructions(EN)

PrintedintheUK.

AllRightsReserved

*3381-622*A

PAGE 1
Form No. 3381-622 Rev A Upper ROPS Frame Kit LT3340, CT2120, CT2140, CT2240, or Groundsmaster® 3400 Traction Unit Model No. 111-7251 Installation Instructions Introduction This product complies with all relevant European directives. For details, please see the Declaration of Incorporation (DOI) at the back of this publication. Carefully read and understand the information in this manual to learn how to fit the hoop to your product properly and avoid injury and product damage.
PAGE 2
Installation Installing the Roll Bar Note: Due to the weight of the roll bar, it is recommended that suitable lifting equipment is used to remove the existing roll bar and install the new roll bar. 1. Park the traction unit on a level surface and apply the parking brake. 2. Lower the cutting units. 3. Stop the engine and remove the ignition key. 4. Remove the existing roll bar; refer to the Operator’s Manual. 5. Raise the roll bar and locate it into position (Figure 1).
PAGE 3
Declaration of Incorporation The Toro Company, 8111 Lyndale Ave. South, Bloomington, MN, USA declares that the following unit(s) conform(s) to the directives listed, when installed in accordance with the accompanying instructions onto certain Toro models as indicated on the relevant Declarations of Conformity. Model No. 111-7251 Serial No.
PAGE 4