Installation Instructions

ManualsBrandsToro ManualsAttachmentsMPH Tachometer Kit, Gas-Powered Workman 3000/4000 Series Vehicles

 2004—The Toro Company

8111 Lyndale Ave., Bloomington, MN 55420, USA

Printed in the USA

Original Instructions (EN)

MPH Tachometer Kit

KPH Tachometer Kit

for Gasoline-powered Workman

)

3000/4000 Series

Vehicles

Model Nos. 105-9498 and 105-9500

Form No. 3327-454 Rev B

Installation Instructions

1. Turn the lights off, remove the key from the ignition

switch, and set the parking brake.

2. Remove the plug from the hole in the dash panel.

3. Locate the wire harness under the dash and cut the wire

tie that secures the tachometer wires to the frame.

4. Pull the wires or connector through the hole in the dash

and carefully cut off the plastic shielding around the

wire terminals.

5. Remove the 2 hex nuts that secure the tachometer clamp

to the tachometer (Fig. 1).

Figure 1

1. Tachometer 2. Tachometer clamp

6. Remove the 4 hex nuts from the tachometer terminal

posts.

Note: For vehicles with serial numbers 240000001 and up,

go to step 8.

7. Connect the appropriate colored wires from the wire

harness to the appropriate terminals on the back of the

tachometer with hex nuts as shown in Figure 2.

Black

Wire

Blue

Wire

Orange

Wire

White or Black

Wire

Figure 2

Note: Set the cylinder selector switch, located on the back

of the tachometer, to position A (Daihatsu engine) or to

position 4 (Mitsubishi engine).

Note: For vehicles with serial numbers prior to 239999999

go to step 11.

8. Remove the tachometer plug from the wire harness.

9. Attach the ring terminals to the terminated wires

(4–6 ring terminal not supplied).

Summary of content (2 pages)

PAGE 1
Form No. 3327-454 Rev B MPH Tachometer Kit KPH Tachometer Kit for Gasoline-powered Workman) 3000/4000 Series Vehicles Model Nos. 105-9498 and 105-9500 Installation Instructions 1. Turn the lights off, remove the key from the ignition switch, and set the parking brake. White or Black Wire 2. Remove the plug from the hole in the dash panel. 3. Locate the wire harness under the dash and cut the wire tie that secures the tachometer wires to the frame. S 4.
PAGE 2
10. Connect the appropriate colored wires from the wire harness to the appropriate terminals on the back of the tachometer with hex nuts as shown in Figure 3. Orange Wire (Existing Ring Terminal) S G I Violet/Red Wire Black Wire Orange Wire Figure 3 Note: Set the cylinder selector switch, located on the back of the tachometer, to position A (Daihatsu engine) or to position 4 (Mitsubishi engine). 11. Before you install the tachometer in the vehicle dash, verify the calibration as follows: A.