Installation Instructions

Installation Instructions
2
Note: If mounting the tine head to MultiCore
Model No. 09697, 09698, or 09699,
you will need parts listed in the table
below which are not included in this
kit. Press the spacers into the tine head
mounting holes (Fig. 1) and use the
fasteners stated in the table to mount
the tine heads to the tine arms. Torque
to 60–70 ft-lbs (85–95 Nm).
Part Number
Quantity Description
100–7604 2 Spacer
33116–045 2 Capscrew
33096–00 2 Washer
33026–00 2 Lock nut
Installing Tine Heads with 12mm
Mounting Holes (Fig. 2)
If your tine heads have mounting holes that measure
12mm (Fig. 2), proceed with the following:
1. Slide the tines completely into the mini tine head
(Fig. 2) and torque the set screws to 35–40 ft-lbs
(50–55 Nm). When installing the tines, use a
piece of wood or a metal plate to hold the tines
into place until the set screws can be tightened.
2. Mount the tine heads to the tine arms with (2)
M12 x 35mm capscrews, lock washers, and flat
washers (Fig. 2). Torque to 60–70 ft-lbs
(85–95 Nm).
2
3
4
Rear of
machine
5
6
1
7
8
Figure 2
1. 12mm mounting hole
2. Tine head
3. Tine arm
4. M12 x 35mm capscrew
5. Lock washer
6. Flat washer
7. Press spacers here
8. Tine
Note: If mounting the tine head to ProCore
Model No. 09700, 09701, or 09702,
you will need parts listed in the table
below which are not included in this
kit. Press the spacers into the tine arm
(Fig. 2) and use the fasteners stated in
the table to mount the tine heads to the
tine arms in the opposite direction
shown in Figure 2. Torque to 60–70
ft-lbs (85–95 Nm).
Part Number
Quantity Description
100–7604 2 Spacer
33116–045 2 Capscrew
33096–00 2 Washer
33026–00 2 Lock nut