Installation Instructions

2
Description UseQty.
Shoulder bolts
Thrust washers, 5/8 inch
Flat washers, 3/8 inch
Locknuts, 3/8 inch
2
4
2
2
Mounting the center of the lift arms to the
machine
Mounting pins
Thrust washers
Klic pins
2
4
2
Mounting the rear of the lift arms to the
machine
Installation instructions 1 Read before installing and operating the kit
Assembling the Blade and the
Lift Arms
1. Using the center holes, assemble the blade to the
channel with 4 carriage bolts (5/16 x 1 inch) and 4
locknuts (5/16 inch). Refer to Figure 1.
Note: The decal on the channel must face upward.
2. Slide the left and right arms into the channel.
3. Secure the arms in place with 4 carriage bolts (5/16 x
1 inch) and 4 locknuts (5/16 inch).
4. Install 4 spacers between the mounting flanges at the
front of the lift arms (2 on each side) and secure them in
place with 4 cap screws (3/8 x 3-3/4 inch) and locknuts
(3/8 inch).
Figure 1
1. Blade
2. Channel
3. Right lift arm
4. Left lift arm
5. Spacer
6. Lower handle
7. Upper handle