Installation Instructions

FormNo.3450-764RevA

PolycarbonateRearWindshieldKit

Workman

UTXPassengerUtilityVehicle

ModelNo.08116

InstallationInstructions

Installation

LooseParts

Usethechartbelowtoverifythatallpartshavebeenshipped.

Description

Qty.

Use

Nopartsrequired

–

Preparethemachine.

Rearwindshieldassembly1

Button-headbolt(M6x30mm)

Flangespacer12

Spacer

Locknut(6mm)

Clamp

Installthekit.

PreparingtheMachine

1.Parkthemachineonalevelsurface.

2.ShiftthetransmissionlevertotheP(Park)position.

3.Shutofftheengineandremovethekey.

8111LyndaleAvenueSouth

Bloomington,MN55420

Registeratwww.T oro.com.

OriginalInstructions(EN)

PrintedintheUSA

AllRightsReserved

*3450-764*

PAGE 1
Form No. 3450-764 Rev A Polycarbonate Rear Windshield Kit Workman® UTX Passenger Utility Vehicle Model No. 08116 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Use Qty. No parts required – Prepare the machine. Rear windshield assembly Button-head bolt (M6 x 30 mm) Flange spacer Spacer Locknut (6 mm) Clamp 1 12 12 10 10 2 Install the kit. Preparing the Machine 1. Park the machine on a level surface. 2.
PAGE 2
Installing the Kit 1. Following the installation order shown in Figure 1, loosely secure the rear windshield assembly to the rear crosslink, rear roll bar tubes, and seat panel using 12 button-head bolts (M6 x 30 mm), 12 flange spacers, 10 spacers, 10 locknuts (6 mm), and 2 clamps as shown in Figure 2. 2. Using the order shown in Figure 1, torque the 12 button-head bolts (M6 x 30 mm) to 10 to 12 N∙m (86 to 106 in-lb).
PAGE 3
g376512 Figure 2 3
PAGE 4