Operator's Manual

2
InstallingtheRollover
ProtectionSystem(ROPS)
Partsneededforthisprocedure:
1
ROPSframe
6
Bolt(1/2inch)
Procedure
1.AligneachsideoftheROPSwiththemountingholes
intheframeateachsideofthevehicleasshownin
Figure4.
Figure4
1.ROPS-mountingbracket2.Flangedbolts(1/2x1-1/4
inch)
2.SecureeachsideoftheROPStoframewith3anged
bolts(1/2x1-1/4inch),andtightentheboltsto115
N-m(85ft-lb).
3
CheckingtheFluidLevels
NoPartsRequired
Procedure
1.Checktheengine-oillevelbeforeandaftertheengine
isrststarted;refertoCheckingtheEngine-oilLevel
(page19).
2.Checkthetransaxle/hydraulic-uidlevelbefore
theengineisrststarted;refertoCheckingthe
Transaxle/Hydraulic-uidLevel(page21).
3.Checkthebrake-uidlevelbeforetheengineisrst
started;refertoCheckingtheBrake-uidLevel(page
23).
13