Installation Instructions

10
SET-UP INSTRUCTIONS
Figure 16
1. Mirror support
2. Mirror
3. Cover
1
2
3
59. Attach mirror to mirror support (Fig. 16).
60. Snap cover over fasteners (Fig. 16).
61. Install seat belts as follows:
A. Remove capscrews and washers securing
rear of seat brackets to frame of machine.
B Secure each end of seat belt assembly to seat
belt bracket as shown in figure 1, with a 7/16-20 x
1" lg. capscrew and locknut. Bent tabs on bracket
to face forward and seat belt latch to be mounted
on end of bracket positioned toward outside of
machine. Tighten nuts securely.
Figure 17
1
2
1. Seat belt latch
2. Seat belt bracket
3. Seat brackets
4. Bent tab
5. Spacer
5
4
5
Passenger seat assembly shown
C. Mount seat belt bracket to seat brackets and
frame with (2) 5/16-18 x 2" lg. capscrews,
washers and spacers. Spacers to be positioned
between seat belt bracket and seat brackets.
D. Secure assembly to underside of frame with
(2) washers and locknuts. Tighten nuts securely.
62. Insert bed support into storage brackets on rear
panel.
63. Install the following decals at locations specified:
 94-5274-Affix to lower front support.
 94-5275-Affix to inside of upper right hand
cab wall.
 94-5276-Affix to inside of upper left hand cab
wall.
 87-7930-Affix to rear panel above bed
support.
 87-5980 (2)-Affix to inside of upper right and
left hand cab walls.
 87-5930-Affix to outside of rear panel near
fuel cap.
 67-1300 (2)-Affix to outside of upper right
and left hand cab walls.
INSTALL OPTIONAL SOFT DOORS
Model 07250
1. Lift door (right or left) and install hinge pins into
hinge receptacles on appropriate cab side frame
(Fig. 18).
Figure 18
1. Door (Glass door shown)
2. Hinge pin
3. Spring assembly rod
1
2
3
2. Shut door and rotate handle knob to latch door.